Adjusting The Side Panels; Adjusting The "Standard" And "Clothing Protector" Side Panels - Otto Bock Voyager Evo Instructions For Use Manual

Settings
"Angle-adjustable" Footrest
1) Loosen the Allen head screws on the clamp bracket (see fig. 34, item 1).
2) Rotate the footplate to the desired angle (see fig. 34, item 2).
3) Tighten the Allen head screws to 10 Nm.
"Angle-adjustable/Depth-adjustable" Footrest
1) Remove the protective caps from the screw connection (see fig. 33, item 3).
2) Loosen the Allen head screws above the footplate (not illustrated).
3) Rotate the footplate to the desired angle (see fig. 33, item 4).
4) Tighten the Allen head screws to 10 Nm. Reinstall the protective caps.
34

6.8 Adjusting the Side Panels

6.8.1 Adjusting the "Standard" and "Clothing Protector" Side Panels

After adjusting the rear wheel position or backrest, the position of the side panels needs to be checked and may
have to be adapted.
Adjusting the Side Panel Depth
1) Loosen the Allen head screws between the side panel and side panel bracket (see fig. 35, item 1).
2) Adjust the side panel as needed. The side panels should be as close against the backrest as possible (see
fig. 35, item 2).
3) Tighten the Allen head screws to 8 Nm (see fig. 35, item 1).
Adjusting the Clothing Protector Lip
1) Loosen the Allen head screws between the side panel and clothing protector lip (see fig. 35, item 3).
2) Adjust the clothing protector lip as needed.
NOTE: Choose the setting so that the lip of the clothing protector is close enough to or far enough
away from the tyre to exclude the risk of crushing.
3) Tighten the Allen head screws to 5 – 7 Nm (see fig. 35, item 3).
Adjusting the Side Panel Bracket
The firm fit of the side panel can be influenced by slightly adjusting the Allen head screws (see fig. 36).
20 | Ottobock Voyager Evo