Recaro® Seat
On the power wheelchair with the Recaro® seat, the attendant controls are attached to the
headrest.
Tools:
❒ Allen wrench, size 3
❒ Open-end or combination wrench, size 10
Steps:
1. Remove the headrest.
2. Guide the metal rods of the headrest through the two loops on the control panel holder.
3. Reattach the headrest to the seat.
4. Adjust the width of the holder with the two set screws.
Properly reassemble all components upon completion of the work.
figure 95
Attendant controls on the Recaro® seat
6.19.7 Installing joystick accessories
Tools:
❒ Allen wrench, size 6
Steps:
1. Slide off the top of the joystick.
2. Slide an accessory such as the fork for tetraplegics, golf ball, stick etc. onto the metal pin.
3. Mount the accessory by tightening the set screw.
Properly reassemble all components upon completion of the work.
89