Otto Bock C2000 Service Instructions Manual page 82

figure 84 Unscrewing the rubber oscillating crank mounts, steering axle
2. Tilt the steering axle / drive axle up on the corresponding spring around the pivot point.
3. Remove the rubber oscillating crank mount and replace single components if required.
Properly reassemble all components upon completion of the work.
NOTICE
Risk of damaging the rubber inserts. When installing the new rubber inserts, note the installation
position.
1
2
figure 85 Installation position of the rubber oscillating crank mounts
1 Rubber oscillating crank mount, steering axle
2 Installation position of rubber insert, steering axle
3 Rubber oscillating crank mount, drive axle
4 Installation position of rubber insert, drive axle
82
3
4