6.12 Lighting
The C2000 power wheelchair is equipped with front and rear lighting as standard equipment.
The lighting functions are activated and deactivated via the controller. The warning flashers and
right / left direction indicator lights are activated using the control panel.
6.12.1 front lights
NOTICE
Risk of damage due to moisture. Do not expose the lamps to moisture. When reinserting the protec-
tive pane, make sure it sits correctly in the housing and that the screws are firmly tightened.
a) Removing the front lights
Preparation:
❒ Remove the side panel (see Section 6.13.10).
❒ Remove the battery case cover (see Section 6.3.2).
Tools:
❒ Allen wrench, size 3
Steps:
1. Open the cable ties along the connection cable up to the connection to the controller.
2. Disconnect the connection to the controller.
3. Loosen and remove two Allen head screws on the side panel.
4. Remove the light including the light holder and replace if required.
Properly reassemble all components upon completion of the work.
figure 32
Removing the front lights
43