Setting / Adjusting The Wheel Lock Release - Otto Bock C2000 Service Instructions Manual

figure 28 Attachment of the Bowden cables on the drive motors
3. Pull the Bowden cables on the drive motors down and out.
4. Loosen and remove two Allen head screws on the wheel lock release at the top of the drive
unit sustainer.
figure 29 Wheel lock release
5. Remove the wheel lock release including the Bowden cables and replace if required.
Properly reassemble all components upon completion of the work.

6.11.2 Setting / Adjusting the Wheel Lock Release

CAUTION
Risk of accidents and injury due to lack of brake functionality. Incorrect wheel lock settings can lead
to a loss of braking power. Repairs and settings must only be made by authorised personnel. Replace
damaged Bowden cables with new ones immediately.
Correct wheel lock settings are essential for safe driving. This is why Otto Bock recommends
inspecting the wheel lock every three months.
To avoid excessive friction, the radius of the Bowden cable must not be less than 10 cm
Damaged Bowden cables must be replaced immediately, for example if individual wires are
protruding or there is a kink in the sheath.
40