Rear Lights - Otto Bock C2000 Service Instructions Manual

figure 34 Replacing the front direction indicator lamp

6.12.2 Rear lights

NOTICE
Risk of damage due to moisture. Do not expose the lamps to moisture. When reinserting the protec-
tive pane, make sure it sits correctly in the housing and that the screws are firmly tightened.
INfORMATION
When ordering spare parts for the rear lighting, note that the rear lighting mount differs between power
wheelchairs with front and rear-wheel drive.
Lamp housings or lamps can be ordered from a specialist dealer.
a) Removing the rear lights, rear-wheel drive
Preparation:
❒ Remove the battery case cover (see Section 6.3.2).
Tools:
❒ Allen wrench, size 6
❒ Open-end or combination wrench, size 13
Steps:
1. Disconnect the connection between the rear lighting and the controller in the battery case.
2. Open the cable ties along the connection cable up to the connection to the controller.
3. Loosen and remove one Allen head screw for each rear lighting element.
4. Remove the light including the light holder and replace if required.
Properly reassemble all components upon completion of the work.
45