Standard Seat And Contour Seat: Adjusting The Seat Depth - Otto Bock C2000 Service Instructions Manual

figure 42 Removing the seat frame
figure 43 Removing the seat frame with seat tilt

6.13.6 Standard seat and contour seat: Adjusting the seat depth

INfORMATION
The seat depth can be adjusted in increments of 20 mm. Use both hands to move the tubes in the seat
frame evenly in order to prevent them from jamming.
Preparation:
❒ Move the seat up until the corresponding screws are freely accessible.
Tools:
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 13
Steps:
1. Loosen and remove the two Allen head screws on the bearing plate.
2. Adjust the position of the bearing plate according to the mounting hole grid.
3. Reposition the footrest according to the mounting hold grid (see Section 6.13.19).
Properly reassemble all components upon completion of the work.
51