Technical Data, Connections; Actuator Outputs - Otto Bock C2000 Service Instructions Manual

8.2.2 Technical Data, Connections

M1, M2: Motors
M1, M2: Brakes
Battery
J4 (bus), J9 (12-pin)

8.2.3 Actuator Outputs

The controller has two independent actuator outputs.
Technical data for the first actuator output:
Voltage
Current for 20 seconds
Steady current
Technical data for the second actuator output:
Voltage
Current for 20 seconds
Steady current
The actuator outputs are short-circuit protected. However, short-circuiting the actuator output
against the negative pole of the battery while the actuator is in operation may damage the out-
put. The actuators have high impedance when they are not in operation.
2.5 – 4 mm
0.5 – 1 mm
2.5 – 4 mm
0.5 – 1 mm
0...100 % V
Batt
20 A
10 A
0...100 % V
Batt
15 A
7 A
Wire gauge
2
2
2
2
103