Installing The Push Button Module - Otto Bock C2000 Service Instructions Manual

6.20.4 Installing the Push Button Module

CAUTION
Risk of health impairment due to a pinched cable. Pinching the cable while operating seat functions
can impair signal transmission by the push button module, resulting in uncontrolled wheelchair behav-
iour. Extreme care is therefore required when installing the cable.
The push button module is attached with a magnetic holder or hook-and-loop connector.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
Tools:
❒ Allen wrench, size 5
Steps:
1. Magnetic holder: Attach the holder for the push button module to the arm rest.
2. Magnetic holder: Attach the push button module to the holder. The push button module is
held in place by two magnets mounted on the back of the holder.
If a magnetic holder is not used, the hook-and-loop holder is freely positioned as required.
figure 100 Holder with attached push button module
3. Connect both plugs to the receptacles on the seat module (see Section 8.3, RSW connec-
tion).
4. Install the fuse.
5. Switch on the control unit.
6. Test the functionality of the push button module.
Properly reassemble all components upon completion of the work.
93