Assembly E: Side Panels; Adjusting The Side Panels: Clothing Protector Version; Replacing The Side Panels: Clothing Protector Version - Otto Bock BRAVO Racer Service Manual

4.5 Assembly E: Side panels

4.5.1 Adjusting the side panels: Clothing protector version

Loosen the screw below the lip of the clothing protector and the side panel mounting screw in
the nut on the seat tube (Figure 75).
Move the side panels lengthwise until they reach the desired position (Figure 76). Use the scale
on the bottom of the seat tubes in order to make sure the position is even on both sides. Retighten
all screws.

4.5.2 Replacing the side panels: Clothing protector version

Loosen and remove the screw connection below the lip of the clothing protector, and the screw
on the eccentric disk (Figure 77). Now you can remove the side panel.
Draw the pull-release cable down and out of the guide, and unhook it from the wheel lock lever
(Figure 78).
Replace the side panel with a new one. For assembly, please proceed in reverse order.
8
75
77
76
78