Replacing The Steering Axle / Drive Axle Rubber Oscillating Crank Mount - Otto Bock C2000 Service Instructions Manual

6.18 Replacing the Steering Axle / Drive Axle Rubber Oscillating Crank Mount
The drive axle and steering axle both have a rubber oscillating crank mount on each end. These
mounts consist of single components that can be replaced separately if required:
❒ Rubber mount bushing
❒ Rubber inserts
❒ Rubber mount cover
❒ Rubber mount bushing insert
The rubber oscillating crank mounts on the steering axle are designed for the maximum load
capacity of 80 –160 kg or 160 – 260 kg.
INfORMATION
In order to assure balanced driving characteristics, Otto Bock recommends replacing the rubber os-
cillating crank mounts and / or their single components in pairs per axle only.
1
figure 83 Rubber oscillating crank mount on the C2000
1 Rubber oscillating crank mount, steering axle
2 Rubber oscillating crank mount, drive axle
Preparation:
❒ Raise the power wheelchair so that the wheels on the corresponding axle can rotate freely.
Tools:
❒ Allen wrench, size 10
Steps:
1. Unscrew the rubber oscillating crank mount on both sides of the steering axle / drive axle.
3
81