Electric Seat Functions; Retrofitting The Electric Seat Tilt (Optional) - Otto Bock C2000 Service Instructions Manual

6.14 Electric Seat Functions
INfORMATION
The installation of electric seat functions requires extensive experience. Contact Otto Bock authorised
personnel directly if required.
INfORMATION
When installing the seat tilt and seat height adjustment functions, observe the correct selection and
position of the seat bracket. Consult the information / installation examples in Section 6.13.9.
INfORMATION
The installation of a seat module is required if more than one electric seat function is installed (see
Section 6.14.4). If this information is provided with the original order, the seat module is pre-assembled
and delivered with the seating unit.
INfORMATION
After new electric seat functions are installed and connected, the control unit has to be reprogrammed.
Please see the EnAble50 instructions for use for more information (647G490=D/GB).

6.14.1 Retrofitting the Electric Seat Tilt (Optional)

The C2000 power wheelchair may be retrofitted with a seat tilt option. It is integrated into the
seat frame and operated by an actuator.
The seat tilt option is delivered as a pre-assembled unit.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
❒ Remove the footrest (see Section 6.13.19).
❒ Remove the seat (see Section 6.13.1).
❒ Remove the seat frame (see Section 6.13.5).
❒ Remove the cables (open cable ties)
Tools:
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 13
❒ Circlip pliers
70