Otto Bock C2000 Service Instructions Manual page 112

Main
Menu
Parameter
Seat
Enhanced display
with Bluetooth
Wheel lock
Actuators &
steering
Driver outputs
Light
Battery
Odometer reset
Hour meter reset
Drive-away lock
Configuration Save system
configuration
Remote control
Seat
112
Submenu
Actuators Parameters to adjust the seat actuators (speed,
1 to 5 current).
The seat module offers a separate 12 volt output. The
voltage can be turned on or off under the "Miscellane-
ous" menu item.
Sound & display The display is needed to control external devices
using infrared. Bluetooth can only be used to control a
Mouse
computer mouse. Bluetooth must be activated first.
Remote control
Parameters that establish when the wheel locks
engage and disengage.
Actuators 2 actuators can be connected to the controller. For
example, speed and current values can be pro-
Steering motor
grammed here.
J1 J1-J3 are programmable outputs. Each of them is
designed for a 2 A load and set to battery +. Pro-
J2
grammable parameters:
J3
– External horn: Output activated by horn function
– Fan: Output activated when the programmed
controller temperature is reached.
– Overvoltage: Output activated when the program-
mable voltage is exceeded
– Reverse motion: Output activated during reverse
motion
– System on: Output activated when the system is
turned on
Parameters for light and direction indicator settings
Parameters for battery settings, which are very time-
consuming to establish. The default settings should be
retained.
Daily and total odometer readings can be reset.
Resets the hours of operation for the drive motors
Turns the drive-away lock function on / off.
The lock is activated when the mode button is pushed
and held for approximately 5 seconds or the corre-
sponding menu item is selected from the aux menu.
However, the mode button cannot be used in this
manner if the "smart button" parameter is activated,
since the long mode command is used to shut down
the system in this case.
Value: On / off
Saves the system configuration with all modules and
checks whether all modules are present.
The menu tree for the enhanced display with Blue-
tooth (LCD) can be set up here. The structure is
customisable.
Actuator configu- The existing seat actuators (functions) are assigned
ration to the outputs in the seat module. Possible limitations
can be programmed via limit switches.
Settings