Connecting External Switches - Otto Bock C2000 Service Instructions Manual

1
figure 101 Push button module connections on the seat module
1 2-pin plug for 12 V power supply
2 12-pin plug for signals

6.20.5 Connecting External Switches

The push button module has 3 inputs on the underside for the connection of external switches,
e.g. Buddy Buttons.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
Steps:
1. Remove the protective pin from the input on the push button module.
2. Plug the Buddy Button connection cable into the input on the push button module.
3. Install the fuse.
4. Switch on the control unit.
5. Test the Buddy Button functionality.
figure 102 Connecting an external switch (here: Buddy Button) to the push button module
94
2