Otto Bock C2000 Service Instructions Manual page 79

figure 79 Removing the lower cover plate
3. Open the cable ties.
4. Disconnect the drive motor connection cable on the controller:
a. Right-hand plug on the controller = right-hand drive motor
b. Left-hand plug on the controller = left-hand drive motor
5. Loosen the Allen head screw that connects the drive motor to the top cover plate.
figure 80 Removing the drive motor
6. Take note of the connection cable assignment on the cable bridge for later assembly:
a. Thick red-black cable: Controller
b. Thick red-blue cable: Red => red, blue => black
c. Yellow-white cable: Wheel lock
7. Disconnect the drive motor connection cable on the cable bridge.
8. Pull the motor down to remove and replace if required.
CAUTION
Risk of accidents due to unsecured screw connections. To install the drive motor, use new screws with
TUFLOC® patch and secure them with a medium-strength thread lock compound (e.g. Loctite 241®).
79