Adjustment Of The Side Panels; Adjusting The "Standard" And "Clothing Protector" Side Panels - Otto Bock Ventus Service Manual

Table of Contents

Advertisement

4) Reinstall the springs, locking pins and key rings (see Page 26).
Installing and Adjusting the Armrest
1) Slide the armrest into the holder (see Fig. 99).
2) Slide the armrest to the desired position (see Fig. 105, Pos. 2).
3) Tighten the mounting screw to 7 Nm (see Fig. 105, Pos. 1).

3.8.4 Adjustment of the side panels

3.8.4.1 Adjusting the "Standard" and "Clothing protector" side panels

Adjusting the "Standard" Side Panels
It is not possible to make an adjustment. After major changes to the position or size of the rear wheels, the side
panels must be replaced (see Page 30).
Adjusting the "Clothing Protector" Side Panels
INFORMATION
Note that the side panels may have to be replaced after major changes to the rear wheel position or size (see
Page 30).
Adjustments can be made.
1) Loosen the Allen head screw on the support bracket (see Fig. , Pos. 1).
2) Remove and, if necessary, replace the side panel.
3) Position the side panel. In order to do so, pass the Allen head screw through one of the 5 bore holes (see
Fig. , Pos. 1) and tighten it on the support bracket.
INFORMATION: Choose the bore hole so that the lip of the clothing protector is close enough to or far
enough away from the tyre to exclude the risk of crushing.
INFORMATION: Note that the side panel mounting may also have to be repositioned after adjusting
the "clothing protector" side panel (see Page 31).
Ventus
97
99
Service Work
98
100
Ottobock | 33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents