Standard And Contour Seat: Replacing The Seat Frame - Otto Bock C2000 Service Instructions Manual

figure 41 Standard seat: Seat plate

6.13.5 Standard and Contour Seat: Replacing the Seat frame

NOTICE
Risk of cable damage. Take note of the cables attached to the seat frame with cable ties. Carefully
cut the cable ties with side-cutting pliers or a knife. Ensure that you do not damage the cables during
this process!
Preparation, standard seat:
❒ Remove the seat pad.
❒ Remove the side panels (see Section 6.13.10).
❒ Remove the footrests (see Section 6.13.19).
Preparation, contour seat:
❒ Remove the seat pad.
❒ Remove the side panels (see Section 6.13.10).
❒ Unscrew the back pad.
❒ Remove the footrests (see Section 6.13.19).
Tools:
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 13
Steps:
1. In case of a seat with electric seat adjustment: Disconnect the electric seat adjustment con-
nection cable on the controller.
2. Loosen all cables connected to the seat frame by cable ties.
3. Remove the seat module (if present) including the mounting plate (see Section 6.14.4).
4. Loosen and remove the Allen head screw on each of the four seat brackets.
5. Remove the seat frame and replace if required.
Properly reassemble all components upon completion of the work.
50