Assembly E: Side Panels; Replacing / Retrofitting / Setting The Clothing Protector - Otto Bock Motus Service Manual

4.5 Assembly E: Side Panels

4.5.1 Replacing / Retrofitting / Setting the Clothing Protector

First remove the rear wheel. Loosen and remove the screw connection between the side panel and
back tube (Fig. 6). Loosen and remove the two screw connections between the side panel and
frame (Fig. 70). You can now remove the side panel. Replace the side panel, if necessary.
The new side panel is attached to the front frame tube with two screws and attached to the back
tube with one screw and a plastic clamp.
Use the array of screw-holes to set the side panel height, so the top panel edge is around 25 mm
higher than the wheels and so fingers can't get trapped in the gap (Fig. 71). If you want to change
from desk side panels to the side panels mentioned here you will also need the mounting kit
81A=SW08.
2 mm
26
6
71
70