Replacing The Seat Module - Otto Bock C2000 Service Instructions Manual

1 2
figure 15 Connections on the controller, disconnecting
1 Actuator, steering motor, steering potentiometer connector
2 Left motor connector (493E62=LK00x)
3 Battery cable connector
4 Right motor connector (493E62=RK00x)
6.7 Replacing the Seat Module
The seat module is attached on the seat frame underneath the seat.
INfORMATION
When connecting the cables, ensure correct assignment.
Preparation:
❒ Make the seat module freely accessible via electric seat functions or remove the seat (see
Section 6.13.1).
❒ Remove the fuse (see Section 6.2).
Tools:
❒ Open-end or combination wrench, size 8
Steps:
1. Loosen all connection cables on the seat module.
2. Loosen and remove two nuts on set screws.
3. Remove the seat module and replace if required.
Properly reassemble all components upon completion of the work.
28
3 4