Programming Devices; Handheld Programming Device - Otto Bock C2000 Service Instructions Manual

❒ The actuator outputs have high impedance when they are not in operation.
INfORMATION
The enAble50 instructions for use 647G490=D/GB contain information on the power supply and ac-
tuator connectors.
8.4 Programming Devices
The enAble50 control unit is programmable, i.e the settings for the various programmable pa-
rameters can be set using a programming device. Two programming devices are available: A
handheld programming device and a PC programming station (PCPS). The PCPS has additional
functions not offered by the handheld programming device. On the other hand, the handheld
programming device is more portable. The PCPS is usually used to establish the initial param-
eter settings, while the handheld programming device is used for changes after deployment.

8.4.1 Handheld Programming Device

The handheld programming device (493U36=SK180) is designed for programming, inspection
and debugging of the wheelchair control.
2
4
figure 113 Handheld programming device
Control and display elements:
1. LCD: Graphic display (128 × 64 pixels) to display functions and parameters.
2. four-directional button: A control element to navigate the cursor in the menu tree. Press
the up / down arrow to move the cursor vertically in the menu tree. Press the right hand ar-
row at the branch points to open the corresponding sub-functions and press the left hand
arrow to closes these sub-functions again.
3. Rocker button: This control element is used to increase or decrease the selected param-
eter values.
4. Programmable bookmarks: 3 user-defined bookmarks. This function enables you to jump
quickly among various points in the menu tree. To set a bookmark, select an item and press
the key for a longer time (at least 3 seconds). Then the cursor will jump to the predefined
position by pressing the key quickly.
1
3
107