Push Button Module; Installing The Push Button Module; Preparing The Push Button Module (Attaching Icons) - Otto Bock C2000 Service Instructions Manual

figure 96 Installing joystick accessories
6.20 Push Button Module

6.20.1 Installing the Push Button Module

CAUTION
Risk of accidents due to uncontrolled driving characteristics. The push button module is an op-
tion for the use of the enAble50 system. Improper adaption of the push-button control unit to a power
wheelchair with components outside of the Otto Bock modular system or later modification by the user
are impermissible.
The push button module can only be used in combination with a seat module.
The on-site service technician decides which functions are controlled by the push button module.
The corresponding configuration of the parameter file for the enAble50 control unit cannot be
completed independently. As a result, the service technician has to download the parameter
file to the PC with the help of a PC programming station (PCPS; see the enAble50 instructions
for use (647G490=D/GB)) and send it to Otto Bock by e-mail with a request for the desired
configuration. Otto Bock will amend / change the configuration file accordingly.
The service technician subsequently uploads the file returned by Otto Bock to the control unit.
The push button module is delivered as an installation kit.

6.20.2 Preparing the Push Button Module (Attaching Icons)

The service technician has to attach the corresponding icons to the push button module accord-
ing to the selected configuration.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
90