Otto Bock C2000 Service Instructions Manual page 111

Main
Menu
Parameter
System General driving
settings
Emergency
operation
Wheelchair
geometry
Reverse beep
Delays
Motor & wheels
Submenu
Max speed The maximum speed parameter forms another layer
above the speed values that can be programmed
under input devices.
Example: Max. speed = 60%.
Forward speed = 80%. In driving mode 1, 0.8 x 60%
= 48% of the normal driving speed.
Max. Limits the maximum RPM.
RPM
Quick stop factor Factor that determines the deceleration, e.g. if the
forward joystick is released while driving.
Quick stop factor
reverse
Emergency stop Parameter that determines the deceleration in case
of problems in the control unit, e.g. the wheelchair is
turned off while driving.
Forward Compensates for speed differences between the
tracking right-hand and left-hand motor. Directional stability
can be improved.
Reverse tracking
V steering limit Determines speed changes in curves.
Mode button Defines whether long or short mode signals have
navigation different meanings.
Profile increase Profile change
stop
All driving parameters if the wheelchair is in an
emergency situation (creep speed).
Parameters that relate to the wheelchair base frame,
e.g. wheelbase.
These parameters should not be changed.
A warning signal can be emitted during reverse
operation. It can be activated or deactivated in the
individual profiles.
Various delays can be programmed.
Automatic The wheelchair turns off after the established delay. It
shutoff does not shut down if the setting is 0.
Stop timeout After the delay specified here, the wheelchair switches
from cruise control operation to normal operation.
Stop timeout Specifies whether the cruise control automatically
deactivated stops after the stop timeout or not.
Drive timeout Delay between the last driving command and auto-
matically switching to the prior mode. No switching if
the parameter is set to 0.
Aux timeout Delay between the last input command and automati-
cally switching to the prior operating mode. No jump if
the parameter is set to 0.
Menu timeout Defines the command time for menu operation.
IR function Delay before the IR menu jumps up one level. No jump
timeout if the parameter is set to 0.
Parameters that adapt the drive motors to the control-
ler. The direction of rotation can be changed.
Settings
111