Replacing The Side Tube; Removing The Drive Motor - Otto Bock C2000 Service Instructions Manual

6.15 Replacing the Side Tube
Tools:
❒ Allen wrench, size 4
Steps:
1. Loosen and remove an Allen head screw at the front and rear of the side tube, respectively.
2. Remove the side tube and replace if required.
Properly reassemble all components upon completion of the work.
figure 78 Removing the side tube
6.16 Removing the Drive Motor
The drive motor is permanently connected to the wheel flange and can only be replaced as a
complete unit.
CAUTION
Risk of injury due to electric current. Turn off the control unit of the power wheelchair and disconnect
the plug connections on the controller before performing any work on the drive motors.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
❒ Remove the drive wheel (see Section 6.8.2).
Tools:
❒ Allen wrench, size 4
❒ Allen wrench, size 5
❒ Side cutting pliers
Steps:
1. Loosen and remove the ten Allen head screws on the lower cover plate.
2. Remove the cover plate.
78