6.6 Replacing the Controller
The controller on the C2000 is attached above the drive axle (on the outside of the battery case).
INfORMATION
When connecting the cables, ensure correct assignment.
Preparation:
❒ Remove the fuse (see Section 6.2).
Tools:
❒ Flat screwdriver
❒ Ring or open-end wrench, size 8
Steps:
1. Remove the cover over the connectors; in order to do so, remove two black cover caps and
loosen and remove two nuts on set screws.
2. Loosen the controller mount; in order to do so, loosen and remove two nuts on set screws.
3. Loosen all connection cables on the controller.
4. Remove the controller and replace if required.
Properly reassemble all components upon completion of the work.
figure 14
Removing the cover, removing the controller
27