Otto Bock C2000 Service Instructions Manual page 118

Menu Tree
Input devices
> Hand control device settings
> Driving
> Profile 1 P1
> Latch Reverse LatchRev
Input devices
> Hand control device settings
> Driving
> Profile 1 P1
> Performance
Table 9 "Driving" parameter settings
118
Access Min Max Default Unit
Service 0 2
Service 20 100 100
0 Constant speed forward / reverse
If 'Constant speed' = cruise is
selected, the wheelchair accelerates to
the desired speed. If the command is
reduced, the wheelchair maintains the
speed. Direction changes are always
possible. The wheelchair decelerates
if an opposing command of 50% or
less is issued. A stop is achieved via a
mode button command or an opposing
command of more than 50%.
If 'Constant speed' = stepped is
selected, the wheelchair accelerates by
one increment with each short com-
mand (33%, 66% and 100%) up to
the maximum speed. Direction changes
are always possible. The wheelchair
decelerates by one increment (e.g. from
66% to 33%) when a brief opposing
command of 50% is issued. A stop is
achieved via a mode switch or with a
permanent opposing command.
Risk of injury due to incor-
WARNING
rectly installed control buttons. Never
select 'Constant speed' mode (cruise
or stepped) unless the mode button is
installed so that the user can operate it
quickly at any time.
% Performance
The performance parameter may be
less than 100% to limit the maximum
torque.
Limiting the torque reduces the power
of the wheelchair. This can prevent
dangerous collisions or crossing
obstacles.
Reducing torque is usually only feasible
for indoor operation.
After reducing the torque, ensure the
user is able to cross any obstacles that
need to be crossed.
Help Text