Retrofitting The Electric Back Angle Adjustment (Optional) - Otto Bock C2000 Service Instructions Manual

6.14.2 Retrofitting the Electric Back Angle Adjustment (Optional)

A back frame with crossbrace, new upholstery and a back rest actuator are required to install
the electric back angle adjustment option.
The electric back angle adjustment option is delivered as a preassembled unit.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
Tools:
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 13
Steps:
1. Remove the back frame from the bearing plate / seat frame.
2. Install the bearing plate with the crossbrace of the electric back angle adjustment option.
3. Install the back frame on the bearing plate / seat frame.
4. Connect the actuator ratchet bolt to the locking mechanism of the crossbrace.
5. Connect the actuator to the controller or seat module.
6. Programme the control unit and test the back angle adjustment function.
Properly reassemble all components upon completion of the work.
NOTICE
Risk of cable damage if cables protrude into the adjustment range. Fasten the connection cable
to the frame with cable ties to prevent it from extending into the adjustment range.
1
figure 72 Retrofitting the electric back angle adjustment
72
2