Adjusting The "Padded" Armrest; Adjusting The "Standard" And "Clothing Protector" Side Panels - Otto Bock Ventus Instructions For Use Manual

Hide thumbs Also See for Ventus:

Table of Contents

Adjustments

6.8.2 Adjusting the "Padded" armrest

1) Loosen the mounting screw on the locking point (see fig. 57, item 1).

2) Slide the armrest to the desired position (see fig. 57. item 2).

3) Tighten the mounting screw.

Adjusting the "Standard" Side Panels

It is not possible to make an adjustment. If a large change to the positions or sizes of the rear wheels has been

made, the side panels must be exchanged.

1) Loosen the Allen head screw on the support bracket (see fig. 58 and see fig. 59, item 1).

2) Remove and replace the side panel.

3) Tighten the Allen head screw on the support bracket.

Adjusting the "Clothing Protector" Side Panels

INFORMATION

Note that the side panels may have to be replaced after major changes to the rear wheel position or size (see

above).

Adjustments can be made.

1) Loosen the Allen head screw on the support bracket (see fig. 59, Pos. 1).

2) Remove and, if necessary, replace the side panel.

3) Position the side panel. In order to do so, pass the Allen head screw through one of the 5 bore holes (see

fig. 59, Pos. 1) and tighten it on the support bracket.

INFORMATION: Choose the bore hole so that the lip of the clothing protector is close enough to or far

enough away from the tyre to exclude the risk of crushing.

INFORMATION: Note that the side panel mounting may also have to be repositioned after adjusting

the "clothing protector" side panel (see the 647G829 service manual).

26 | Ottobock

Ventus

Table of Contents