Adjusting The "Padded" Arm Support; Adjusting The "Standard" And "Clothing Guard" Side Panels - Otto Bock Ventus Instructions For Use Manual

Adjusting the depth of the armrest
1) Loosen the mounting screws (see fig. 53, item 1).
2) Remove the armrest and move it (see fig. 53, item 2).
3) Screw in the armrests again.
52

6.8.2 Adjusting the "padded" arm support

1) Loosen the mounting screw on the locking point (see fig. 55, item 1).
2) Slide the armrest to the desired position (see fig. 55, item 2).
3) Tighten the mounting screw.
54

6.8.3 Adjusting the "standard" and "clothing guard" side panels

Adjusting the "standard" side panels
It is not possible to make an adjustment. If a large change to the positions or sizes of the drive wheels has been
made, the side panels must be exchanged.
1) Loosen the Allen head screw on the support bracket (see fig. 56 and see fig. 57, item 1).
2) Remove and replace the side panel.
3) Tighten the Allen head screw on the support bracket.
Adjusting the "clothing protector" side panels
INFORMATION
Note that the side panels may have to be replaced after major changes to the drive wheel position or size (see
above).
Adjustments can be made.
1) Loosen the Allen head screw on the support bracket (see fig. 57, Pos. 1).
2) Remove and, if necessary, replace the side panel.
Ventus
53
55
Settings
25