Replacing The Charging Receptacle - Otto Bock C2000 Service Instructions Manual

6.5 Replacing the Charging Receptacle
INfORMATION
When connecting the cables, ensure correct assignment.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
❒ Remove the seat including seat frame (see Section 6.13.1 and 6.13.5).
❒ Remove the batteries (see Section 6.3.2).
Tools:
❒ Allen wrench, size 3
❒ Small Phillips screwdriver
Steps:
1. Loosen the charging receptacle connection cable on the controller.
2. Disconnect all cable ties on the connection cable between the charging receptacle and the
controller.
3. Loosen two slotted head screws on the front of the charging receptacle.
4. Pull out the charging receptacle including connection cable and replace if required.
Properly reassemble all components upon completion of the work.
figure 13 Removing the charging receptacle
26