Retrofitting The Seat Module - Otto Bock C2000 Service Instructions Manual

6.14.4 Retrofitting the Seat Module

INfORMATION
For information on connecting the seat module, please see Section 6.2.
After new electric seat functions are installed and connected, the control unit has to be reprogrammed.
Please see the EnAble50 instructions for use for more information (647G490=D/GB).
Controlling more than one electric seat function requires the installation of a seat module.
The seat module is installed on a metal brace below the seat (included in the scope of delivery).
INfORMATION
When connecting the cables, ensure correct assignment.
Preparation:
❒ Turn the control unit off.
❒ Remove the fuse (see Section 6.2).
Tools:
❒ Allen wrench, size 3
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 8
❒ Open-end or combination wrench, size 13
Steps:
1. Install the seat module on the metal brace.
2. Remove the seat / seat plate.
3. Screw the metal brace in place using oval head screws / self-locking nuts.
4. Connect the seat module to the controller.
Properly reassemble all components upon completion of the work.
figure 74 Retrofitting the seat module
74