figure 44
Adjusting the seat depth: Repositioning the bearing plate and footrest
6.13.7 Standard seat and contour seat: Adjusting the seat height
NOTICE
Risk of cable damage. Ensure the cables attached to the frame with cable ties are not damaged.
Changing the seat height requires replacement of the seat brackets.
Preparation:
❒ Remove the seat plate (see Section 6.13.4).
Tools:
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 13
Steps:
1. Remove the black plastic caps of the rear Allen head screws.
2. Loosen and remove the Allen head screws on the two rear brackets.
3. Loosen and remove the Allen head screws on the two front brackets.
4. Loosen and remove the seat brackets from the seat frame.
5. Select and install seat brackets according to Table 3 and Table 4.
Properly reassemble all components upon completion of the work.
6.13.8 Standard seat and contour seat: Adjusting the seat angle
NOTICE
Risk of cable damage. Ensure the cables attached to the frame with cable ties are not damaged.
The seat angle is adjusted via the screw connection on the connecting bracket.
Preparation:
❒ Remove the seat plate (see Section 6.13.4).
52