Replacing The Bearing Plate (Standard And Contour Seat); Standard And Contour Seat: Replacing The Seat Plate - Otto Bock C2000 Service Instructions Manual

6.13.3 Replacing the Bearing Plate (Standard and Contour Seat)

Tools:
❒ Allen wrench, size 5
❒ Open-end or combination wrench, size 13
Steps:
1. Loosen the three Allen head screws.
2. Remove the bearing plate and replace if required.
Properly reassemble all components upon completion of the work.
INfORMATION
The screw in the middle of the plate serves as stop for the back angle adjustment.
figure 40 Removing the bearing plate

6.13.4 Standard and Contour Seat: Replacing the Seat Plate

Steps:
1. Remove the seat cushion.
2. Unlock the back rest and fold it forward.
3. Pull the seat plate up with a sharp tug and replace if required.
Properly reassemble all components upon completion of the work.
49