Wheel Installation; Tire Inspection; Tire Pressure - Polaris RZR PRO R Service Manual

MAINTENANCE

WHEEL INSTALLATION

1. Verify the transmission is still in PARK.
2. Place the wheel in the correct position on the wheel
hub. Be sure the valve stem is toward the outside and
rotation arrows on the tire point toward forward
rotation.
3. Attach the wheel nuts
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts to the proper torque
specification.
TORQUE
Wheel Lug Nuts:
148 ft-lbs (200 Nm)
If wheels are improperly installed it could affect vehicle
handling and tire wear.
2.26
q
and finger tighten them.
CAUTION

TIRE INSPECTION

• Improper tire inflation may affect vehicle
maneuverability.
• When replacing a tire always use original equipment
size and type.
• The use of non-standard size or type tires may affect
vehicle handling.
MEASUREMENT
Tire Lug Service Limit:
Replace if 1/8" (3 mm) or less.
Operating with worn tires will increase the possibility of
the vehicle skidding easily with possible loss of control.
Worn tires can cause an accident. Always replace tires
when the usable tread depth has worn out.

TIRE PRESSURE

Remove the valve stem cap and check tire pressure
using the tire pressure gauge included in the vehicle's
tool kit.
TIRE PRESSURE SPECIFICATION (COLD)
MODEL FRONT
15 psi (103
RZR PRO R
18 psi (124
RZR PRO R 4
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
WARNING
REAR
15 psi (103
kPa) kPa)
18 psi (124
kPa) kPa)
© Copyright Polaris Industries Inc.