Table of Contents
Advertisement
MAINTENANCE
FINAL DRIVE MAINTENANCE
DRIVE SHAFT BOOT INSPECTION
Inspect the front and rear drive shaft boots
damage, tears, wear or leaking grease. If the boots
exhibit any of these symptoms, they should be replaced.
Check to see the boot clamps
WHEEL SERVICE
REMOVAL
1. Position the vehicle on a level surface.
2. Place the transmission in PARK and stop the engine.
3. Loosen the wheel nuts
4. Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
Ensure the vehicle is properly supported and does not
tip or fall.
5. Remove the wheel nuts
2.52
q
for
w
are properly positioned.
q
.
CAUTION
q
and remove the wheel
INSTALLATION
1. Install the wheel
stem toward the outside. Be sure rotation arrow on
the tire (if applicable) points toward the front of the
vehicle.
2. Attach the wheel nuts
Do not lubricate the stud or the lug nut.
3. Carefully lower the vehicle to the ground.
4. Torque wheel nuts
specification.
Wheel Lug Nuts (Steel):
Wheel Lug Nuts (Aluminum)
w
.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
w
e
on the wheel hub
q
and finger tighten them.
NOTICE
q
r
and/or hub nut
to the proper
TORQUE
60 ft-lbs (81 Nm)
120 ft-lbs (163 Nm)
© Copyright Polaris Inc.
with the valve
Advertisement
Chapters
Table of Contents
Troubleshooting
