Emptying The Waste Containers - Oce CS191 Phase 3 User Manual

Replacing toner cartridges and staples and emptying waste containers
10.4

Emptying the waste containers

If the hole-punch waste container in punch kit installed on finisher becomes
full, the message shown below appears (if it can be emptied by the user).
Note
The setting for emptying the hole-punch waste container should be
specified by the technical representative. For details, contact the
technical representative.
The default setting is "Service". If a message appears, immediately
contact the technical representative.
Display for the punch dust box setting
CS191 (Phase3)
10
10-23