Oce CS191 Phase 3 User Manual page 113

Before making copies
!
Detail
When the control panel is turned on by pressing the sub power switch,
the indicator on the [Start] key lights up in orange, and a screen indicating
that the machine is starting up appears.
After a few seconds, the message "Now warming up. Ready to scan."
appears on the touch panel, and the indicator on the [Start] key lights up
in green, indicating that a job can now be queued.
The default settings are those that are selected immediately after the
machine is turned on (the power switch is set to "n") and before any
setting is specified from the control panel or touch panel, and those that
are selected when the [Reset] key is pressed to cancel all settings
specified from the control panel or touch panel. The default settings can
be changed. For details, refer to "Initial setting" on page 13-32.
The factory default settings are the settings that were selected when this
machine was sent from the factory.
Note
A job can also be queued while the machine is warming up after the sub
power switch is pressed. For details, refer to "To scan during warm-up"
on page 3-28.
After the machine has finished warming up, the scanned image will be
printed.
The machine takes about 72 seconds to warm up at normal room
temperature (23°C) when the control panel is turned on using the sub
power switch after the machine is turned on using the main power switch.
CS191 (Phase3)
3
3-27