Table of Contents
Advertisement
13
7
Check the horizontal position of the punched holes.
–
To increase width A, touch [+] to increase the adjustment (between
1 mm and 10 mm).
–
To decrease width A, touch [–] to decrease the adjustment
(between -1 mm and -10 mm).
–
To scroll through the values quickly, touch [+] or [–] continuously.
8
Touch [OK].
–
To cancel changes to the settings, touch [Cancel].
The punch horizontal position is adjusted.
If no adjustment of the horizontal position of the punched holes was
necessary in step 7, this completes the procedure.
9
Use the "Punch" function to print a another sample copy.
13-80
A
A
Utility
CS191 (Phase3)
Advertisement
Table of Contents
Troubleshooting
