Utility
7
Compare the width of the left pages of the copy sample with the width
of the right pages to check for the center of the paper.
–
If the staple position is too far to the left of the center of the paper,
touch [+] to increase the adjustment (between 1 mm and 10 mm).
–
If the staple position is too far to the right of the center of the paper,
touch [–] to reduce the adjustment (between –1 mm and –10 mm).
–
To scroll through the values quickly, touch [+] or [–] continuously.
8
Touch [OK].
–
To cancel changes to the settings, touch [Cancel].
The center stapling position is adjusted.
If the stapling position was at the center of the paper in step 7, this
completes the procedure.
9
Use the "Fold & Staple" function to print a another sample copy.
10
Check the print result.
–
Check that the stapling position is adjusted to the center of the
paper.
–
If more adjustment is necessary, repeat steps 1 and 9.
CS191 (Phase3)
13
13-77