Oce CS191 Phase 3 User Manual page 236

4
3
Touch [Position].
– Touch the button for the desired position, and then touch [OK].
– Touch [Auto] to automatically determine the stapling position
according to the orientation of the loaded original. If the original
length is 297 mm or less, the long side of the paper is stapled. If the
original length is more than 297 mm, the short side of the paper is
stapled.
– If "Auto" is selected, the stapling position is set at the top or at the
left.
– To cancel changes to the stapling position, touch [Cancel].
– To specify the output tray, touch the button for the desired tray
under "Output Tray".
4
Touch [OK].
The Basic screen appears again.
4-92
Basic copy operations
CS191 (Phase3)