Utility
7
Press the [Start] key.
A test pattern is printed.
8
Check that the distance from the starting print position of the test
pattern to the edge of the paper (a) is 4.2 mm.
–
If the distance is less than 4 mm, touch [+] to increase the
adjustment (between 0.2 mm and 3.0 mm).
–
If the distance is more than 7 mm, touch [–] to reduce the
adjustment (between –0.2 mm and –3.0 mm).
–
To scroll through the values quickly, touch [+] or [–] continuously.
9
Press the [Start] key.
The adjusted test pattern is printed.
10
Check the distance from the starting print position of the test pattern
to the edge of the paper.
–
Check that the width has been adjusted to 4.2 mm.
–
If more adjustment is necessary, repeat steps 8 and 9.
–
To adjust the print position for a different type of paper, return to
step 6.
11
Touch [OK].
–
To cancel changes to the settings, touch [Cancel].
The print position is adjusted.
CS191 (Phase3)
a: 4.2 mm
a
13
13-65