Oce CS191 Phase 3 User Manual page 239

Basic copy operations
3
Touch [Position].
– Touch the button for the desired position, and then touch [OK].
– Touch [Auto] to automatically determine the position of the
punched holes according to the orientation of the loaded original. If
the original length is 297 mm or less, the holes are punched along
the long side of the paper. If the original length is more than 297
mm, the holes are punched along the short side of the paper.
– If "Auto" is selected, the punched hole position is set at the top or
at the left.
– To cancel changes to the punched hole position, touch [Cancel].
– To specify the output tray, touch the button for the desired tray
under "Output Tray".
4
Touch [OK].
The Basic screen appears again.
CS191 (Phase3)
4
4-95