Display System Components; Disable System Components - Sun Oracle SPARC T3-2 Service Manual

▼ Display System Components

The show components command displays the system components (asrkeys) and
reports their status.
●
At the -> prompt, enter the show components command.
In the following example, PCIE3 is shown as disabled.
-> show components
Target
--------------------+------------------------+-------------------------------
/SYS/MB/RISER0/
PCIE0
/SYS/MB/RISER0/
PCIE3
/SYS/MB/RISER1/
PCIE1
/SYS/MB/RISER1/
PCIE4
/SYS/MB/RISER2/
PCIE2
/SYS/MB/RISER2/
PCIE5
/SYS/MB/NET0
/SYS/MB/NET1
/SYS/MB/NET2
/SYS/MB/NET3
/SYS/MB/PCIE
Related Information
"View the System Message Log Files" on page 37
■
"Disable System Components" on page 56
■
"Enable System Components" on page 57
■

▼ Disable System Components

You disable a component by setting its component_state property to Disabled.
This adds the component to the ASR blacklist.
1. At the -> prompt, set the component_state property to Disabled.
-> set /SYS/MB/CMP0/BR1/CH0/D0 component_state=Disabled
56 SPARC T3-2 Server Service Manual • December 2013
| Property
| component_state
|
| component_state
|
| component_state
|
| component_state
|
| component_state
|
| component_state
|
| component_state
| component_state
| component_state
| component_state
| component_state
| Value
| Enabled
|
| Disabled
|
| Enabled
|
| Enabled
|
| Enabled
|
| Enabled
|
| Enabled
| Enabled
| Enabled
| Enabled
| Enabled