Fault Management Command Examples; Show Faulty Example Of A Power Supply Fault - Sun Oracle SPARC T3-2 Service Manual

Fault Management Command Examples

When no faults have been detected, the show fault output looks like this:
-> show faulty
Target
--------------------+------------------------+-------------------
-----------------------------------------------------------------
Other examples are shown in the following sections.

show faulty Example of a Power Supply Fault

The following is an example of the show faulty command reporting a power
supply fault.
Note – The characters "SPT" at the beginning of the message ID indicate that the
fault was detected by Oracle ILOM.
-> show faulty
Target
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
32 SPARC T3-2 Server Service Manual • December 2013
| Property
| Property
| fru
| class
|
| sunw-msg-id
|
| uuid
|
| timestamp
|
| fru_part_number
|
| fru_serial_number
|
| product_serial_number
|
| chassis_serial_number
|
| detector
|
| Value
| /SYS/PS0
| fault.chassis.power.volt-fail
|
| SPT-8000-LC
|
| ********-****-****-****-************
|
| 2010-08-11/14:54:23
|
| *******
|
| ******
|
| **********
|
| **********
|
| /SYS/PS0/VOLT_FAULT
|
| Value