Sun Oracle SPARC T3-2 Service Manual page 184

9. Use the probe-scsi-all command to confirm that you reactivated the volume.
ok probe-scsi-all
/pci@400/pci@2/pci@0/pci@e/scsi@0
FCode Version 1.00.54, MPT Version 2.00, Firmware Version 5.00.17.00
Target a
Unit 0 Removable Read Only device
SATA device PhyNum 3
Target b
GB Unit 0 Disk
SASDeviceName 5000c50016f75e4f
Target 389 Volume 0
Unit 0 Disk
VolumeDeviceName 33b2999bca4dc677
/pci@400/pci@1/pci@0/pci@b/pci@0/usb@0,2/hub@2/hub@3/storage@2
Unit 0 Removable Read Only device
10. Set the auto-boot? OpenBoot PROM variable to true so the system will boot
the OS when powered-on.
ok setenv auto-boot? true
11. Reboot the server.
Related Information
"Install the Motherboard" on page 167
■
"Reactivate RAID Volumes" on page 170
■
"Verify Motherboard Functionality" on page 173
■
172 SPARC T3-2 Server Service Manual • December 2013
SEAGATE ST914603SSUN146G 0868
SASAddress 5000c50016f75e4d
LSI Logical Volume
TEAC DV-W28SS-R
3000 583983104 Blocks, 298 GB
VolumeWWID 03b2999bca4dc677
AMI Virtual CDROM
1.0C
286739329 Blocks, 146
PhyNum 1
1.00