Verify Service Processor Functionality - Sun Oracle SPARC T3-2 Service Manual

▼ Verify Service Processor Functionality

1. Verify that the SP Status LED is illuminated green.
Note that the LED will flash green while the service processor initializes the ILOM
firmware. See
information about the status of the SP LED.
2. Run the ILOM show faulty command to verify that the fault has been cleared.
See "Managing Faults With ILOM" on page 22
show faulty command.
3. Perform one of the following tasks based on your verification results:
If the previous steps did not clear the fault, see
■
Faults" on page 15
diagnose component faults.
If the previous steps indicate that no faults have been detected, then the
■
component has been replaced successfully. No further action is required.
"Front and Rear Panel System Controls and LEDs" on page 20
for information about the tools and methods you can use to
for more information on using the
"Detecting and Managing
Servicing the Service Processor
for
181