Sun Oracle SPARC T3-2 Service Manual page 143

Note – Use the show /HOST command to determine when the host has been
powered off. The console will display status=Powered Off. Allow approximately
one minute before running this command.
c. Switch to the system console to view POST output.
Watch the POST output for possible fault messages. The following output
indicates that POST did not detect any faults:
-> start /SYS/console
.
.
.
0:0:0>INFO:
0:0:0> POST Passed all devices.
0:0:0>POST: Return to VBSC.
0:0:0>Master set ACK for vbsc runpost command and spin...
Note – The server might boot automatically at this point. If so, go directly to
If it remains at the ok prompt go to
d. If the system remains at the ok prompt, type boot.
e. Return the virtual keyswitch to Normal mode.
-> set /SYS keyswitch_state=normal
Set 'ketswitch_state' to 'normal'
f. Switch to the system console and type the Oracle Solaris OS fmadm faulty
command.
# fmadm faulty
If any faults are reported, refer to the diagnostics instructions described in
"Oracle ILOM Troubleshooting Overview" on page
5. Switch to the Oracle ILOM command shell.
Step d.
25.
Servicing Memory Risers and DIMMs
Step e.
131