SPARC T3-2 Server Getting Started Guide This guide describes the minimum steps you must perform to power on and boot Oracle’s SPARC T3-2 server for the first time using the preinstalled Oracle Solaris Operating System (Solaris OS). For complete installation instructions, refer to the SPARC T3-2 Server Installation Guide.
Before You Begin For quick installation and configuration, follow these steps. For more detailed information, refer to the complete online product documentation set at: http://docs.sun.com/app/docs/prod/sparc.t3.2#hic. Understand the following information before you set up the server for the first time: Do not apply power until instructed to do so – This system includes a service processor (SP) that is used to ■...
2. Place the server in its intended location for verification. For rackmounting instructions, refer to the online SPARC T3-2 Server Installation Guide. 3. Connect a serial cable between the server’s SER MGT port ( ) and a terminal device.
Page 4
Server Connections FIGURE 1 4. (Optional) Connect an Ethernet cable between the server’s NET MGT port and the network to which future connections to the SP and host will be made. After the initial configuration of the system using the SER MGT port, communication with the SP and host is usually performed through this Ethernet interface.
Page 5
7. At the terminal device, log in to the SP as root with a password of changeme. SUNSP00144FAC732F login: root Password: changeme . . . -> After a brief delay, the SP prompt is displayed (->). At this point, there are many commands you can perform using the Integrated Lights Out Manager (ILOM) interface.
Accessing Additional Information You can view, print, and download additional information for this product from the following web sites: Oracle’s SPARC T3-2 server documentation set, including important documents such as product notes: ■ http://docs.sun.com/app/docs/prod/sparc.t3.2#hic A broad selection of documentation, including localized versions: ■...