Table of Contents
Advertisement
Caution – Do not leave DIMM slots empty. You must install filler panels in all
empty DIMM slots.
1. Consider your first steps:
Familiarize yourself with DIMM configuration rules.
■
See
"DIMM Population Rules" on page
Prepare the system for service.
■
See
"Preparing for Service" on page
If you are replacing a faulty DIMM, locate the memory riser containing the
■
faulty DIMM(s).
See
"Locate a Faulty DIMM (DIMM Fault Remind Button)" on page
Remove the memory riser(s).
■
See
"Remove a Memory Riser" on page
2. Push down on the ejector tabs on each side of the DIMM until the DIMM is
released.
Caution – DIMMs and heat sinks on the motherboard might be hot.
3. Grasp the top corners of the DIMM and lift it out of its slot.
4. Place the DIMM on an antistatic mat.
5. Repeat
Step 2
through
6. Determine if you are installing replacement DIMMs at this time.
112.
63.
120.
Step 4
for any other DIMMs you intend to remove.
Servicing Memory Risers and DIMMs
117.
123
Advertisement
Table of Contents
Need help?
Do you have a question about the SPARC T3-2 and is the answer not in the manual?
Questions and answers