Configure How Post Runs - Sun Oracle SPARC T3-2 Service Manual

▼ Configure How POST Runs

1. Access the ILOM -> prompt.
See
2. Set the virtual keyswitch to the value that corresponds to the POST
configuration you want to run.
The following example sets the virtual keyswitch to normal, which will configure
POST to run according to other parameter values.
-> set /SYS keyswitch_state=normal
Set 'keyswitch_state' to 'Normal'
For possible values for the keyswitch_state parameter, see
that Affect POST Behavior" on page
3. If the virtual keyswitch is set to normal, and you want to define the mode,
level, verbosity, or trigger, set the respective parameters.
Syntax:
set /HOST/diag property=value
See
parameters and values.
Examples:
-> set /HOST/diag mode=normal
-> set /HOST/diag verbosity=max
4. To see the current values for settings, use the show command.
Example:
-> show /HOST/diag
/HOST/diag
48 SPARC T3-2 Server Service Manual • December 2013
"Access the Service Processor (Oracle ILOM)" on page
"ILOM Properties that Affect POST Behavior" on page 46
Targets:
Properties:
error_reset_level = min
error_reset_verbosity = min
hw_change_level = min
hw_change_verbosity = min
level = min
mode = off
power_on_level = min
power_on_verbosity = min
46.
24.
"ILOM Properties
for a list of