Sun Oracle SPARC T3-2 Service Manual page 204

b. Install the motherboard and the four bus bar screws that secure the
Note – Using a No. 2 screwdriver, tighten the bus bar screws until the power supply
backplane and the motherboard securely fasten to the bus bars.
c. Replace the power supply backplane cover and fasten it in place with the
4. Reconnect the ribbon cable from the motherboard to the power supply
backplane.
5. Reinstall the air divider by sliding it into the chassis.
6. Reinstall the memory risers or filler panels.
See
7. Push the power supplies all the way back into the chassis.
See
8. Return the server to operation:
a. Install the top cover.
b. Return the server to the normal rack position.
c. Reinstall the power cords to the power supplies and power on the server.
Related Information
"Remove the Power Supply Backplane" on page 189
■
"Verify Power Supply Backplane Functionality" on page 193
■
192 SPARC T3-2 Server Service Manual • December 2013
motherboard to the power supply backplane.
This will also involve reconnecting all cables that connect the power supply
backplane, disk drive backplane, and fan board to the motherboard.
See "Install the Motherboard" on page
screw.
"Install a Memory Riser" on page
"Install a Power Supply" on page
See "Install the Top Cover" on page
See "Return the Server to the Normal Rack Position" on page
See "Returning the Server to Operation" on page
167.
121.
106.
196.
195.
197.